iCarsoft CR Pro Bildiagnostik Nu finns det Svenskt språk i menyn - uppdatera din programvara via icarsoft. CR Pro fungerar till ett 40-tal biltillverkare med obd2-uttag. Honda, Isuzu, Hyundai, Kia, Daewoo, Mazda, Ford, Sprinter, BMW, Mini, VW, Säte, Skoda, Volvo, Porsche, SAAB, EU Ford, Holden, Ford Ford , Acura, Subaru, Mitsubishi, Dacia, Renault, Fiat, GM, Chrysler, Mercedes-Benz, Citroen, Jaguar, Peugeot, Audi, Opel, Land Rover, Smart, Suzuki, Vauxhall, Alfa-Romeo, Lancia. Felkodsläsare som även kan läsa av servicelampor och elektroniska bromsar EBP. Felkodsläsaren iCarsoft CR Pro kan släcka motorlampan och nollställa andra felkoder i din bil. En iCarsoft felkodsläsare som hittar i stort sett allt på ditt Fordon. De system som stöds är bland annat: Fullständig ECU diagnos Olje Service Återställning Elektroniskt parkeringsbroms (EPB) systemunderhåll Batteriladdningssystem (BMS) Dieselpartikelfilter (DPF) Regenereringsstyrsystem Elektroniskt styrsystem (ETC) Styrvinkel Sensor (SAS) Kalibrering Läs och Rens DTC Läs Live Date Batteritest Data Granskning och Skriv ut
OBDII FUNCTION
- Read Codes
- Erase Codes
- I/M Readiness – I/M Readiness indicate whether or not the various emissions-related systems on the vehicle are operating properly and are ready for Inspection and Maintenance testing.
- Data stream.
- Freeze Frame – When an emission-related fault occurs, certain vehicle conditions are recorded by the on-board computer. This information is referred to as freeze frame data. Freeze Data is a snapshot of the operating conditions at the time of an emission-related fault.
- O2 Sensor Test – This option allows retrieval and viewing of O2 sensor test results for most recently performed tests from the vehicle’s on-board computer.
- On-Board Monitoring – This function can be utilized to read the results of on-board diagnostic monitoring tests for specific components/systems.
- Evap System Test – The EVAP test function lets you initiate a leak test for the vehicle’s EVAP system. Before using the system test function, refer to the vehicle’s service repair manual to determine the procedures necessary to stop the test.
- Vehicle Information – The option displays the vehicle identification number (VIN), the calibration verification number (CVN), and other information of the test vehicle.
- Retrieve generic (P0, P2, P3, and U0), manufacturer specific (P1, P3, and U1) codes and pending codes 11.Turn off Check Engine Light (MIL), clear codes and reset monitors
- Read live PCM DataStream
- Support CAN (Controller Area Network) and all other
- Multilingual menu and DTC definitions- English, Spanish, and German, etc
- Read pending DTCs
- Read permanent DT
